The belt grinder has now all the wheels newly surfaced with micarta and all 30 mm diameter wheels were increased to 60 mm.

Subjectively it runs quieter and smoother now, unfortunately, I did not make a noise measurement before to have an objective comparison. I still have the previous tracking and spanning wheels, but not the motor wheel, so I cannot get it to the previous state now – shame that I did not think of that but whatever. Maybe I will try it with the smaller wheels, maybe not, because when I was at it, I ground even the previous wheels to better roundness than they were, so even they should now run smoother. I will keep the 30 and 40 mm wheels to grind fullers and finger grooves.

The belt grinder has done a lot of work over the years and it shows, but it needs more improvements. The spanning wheel still does not work as well as it should and the belt is not entirely sideways stable.  I do not know how to do that yet, unfortunately. But I do know how to improve the platen behind the belt to make it more stable. That should be done next week when I get some 50×10 mm mild steel that I ordered. I had to order it, because I had nothing suitable in my scrap pile to use, which sucks since money is short.