I am finishing the kitchen-knives sets, and one of the tools that I was still missing in my toolbox was a branding stamp that could be used for wood and leather. For leather, I have used an impromptu one made from wood stabilized with epoxy, but that cannot be used to brand wood of course. But when making that I have figured out a process that could be also applied to making one out of steel, so after a lot of procrastinating the task, today I have finally bitten the bullet and took the two hours it needed.

© Charly, all rights reserved. Click for full size

The handle is from an extremely old and out-of-shape potato peeler. Maybe even antique, but I know of no museum that would take it of my hands so I have recycled it. The screw is recycled from old furniture. The stamp itself is from tool steel, although I will not be hardening it.

I could not tap the hole in the stamp very deep and well without re-grinding and thus destroying the taps, because standard taps need to go through.  Thus I could not cut very good threads in there, just two turns of half-assed ones. But that should not be a problem, a few dents for the thread to latch on to should suffice, friction should take care of the rest. It is not supposed to come apart, and if it comes apart, I will braze it.

© Charly, all rights reserved. Click for full size

The one advantage of having a logo consisting of only straight lines is that it made the job relatively easy. A bit of filing, a bit of grinding with an angle-grinder, and here we go. Up close there are some flaws and the width to height ratio is a tiny bit off, but that is just life. I have tossed one attempt due to flaws, but I think this one will do.

© Charly, all rights reserved. Click for full size

Wood branding is not an exact science, there will always be some irregularities. But with some practice, I should get crisp and nice logos that can be placed even in visible areas. Which is my intention.

© Charly, all rights reserved. Click for full size

And there is absolutely no doubt that on leather, the results are way, way better than those I got with my wood-carved impromptu stamp.

I may give it a go one more time to get the proportions better, but in the meantime, I am going to use this one. I doubt anyone will complain about it.